The theory behind the arc to keep happening is, the electric current was forced between the tip of your steel welding rod and welding. If you want to be a successful welder you should be able to strike the arc and keep it going even without thinking about it.
The two most common ways to start your bow by pressing and scratching for steel welding rod. Scratching seems to be the most natural way used by beginners.
Scratching is when you swipe across the steel rod as if you were trying to light a match. After making contact with a steel rod, the arc starts. The real reason just to scratch it to start is so it will not stick to steel because it is moving. The trick then is to find where you want to weld and try to keep the arc going. It takes practice to get the hang of it.
Tapping basically stabbed with steel welding rod you. It's better to start the welding rod you in the right location, but it is more difficult to keep the rod from sticking and keeps the bow. Is a natural reaction after a bow, you'll want to pull it to prevent sticking. The only problem is, beginners tend to pull it too far and lose the arc. This can go on and on and actually quite funny to see someone doing this. But we all need to remember we had at one point as well.
Stick of your welding rod caused by the melting of the steel rod before pulling back a little to maintain the arc. I will not discuss how far it should be of steel as it depends on the type of rod you use and your amperage welding with.
These are the basics and should give an idea of how to strike the arc. Just remember that it takes practice and patience to get good. One day you'll take a stinger and it's all going to click in your head. Will begin to feel almost natural, then you'll know it all comes together.
The two most common ways to start your bow by pressing and scratching for steel welding rod. Scratching seems to be the most natural way used by beginners.
Scratching is when you swipe across the steel rod as if you were trying to light a match. After making contact with a steel rod, the arc starts. The real reason just to scratch it to start is so it will not stick to steel because it is moving. The trick then is to find where you want to weld and try to keep the arc going. It takes practice to get the hang of it.
Tapping basically stabbed with steel welding rod you. It's better to start the welding rod you in the right location, but it is more difficult to keep the rod from sticking and keeps the bow. Is a natural reaction after a bow, you'll want to pull it to prevent sticking. The only problem is, beginners tend to pull it too far and lose the arc. This can go on and on and actually quite funny to see someone doing this. But we all need to remember we had at one point as well.
Stick of your welding rod caused by the melting of the steel rod before pulling back a little to maintain the arc. I will not discuss how far it should be of steel as it depends on the type of rod you use and your amperage welding with.
These are the basics and should give an idea of how to strike the arc. Just remember that it takes practice and patience to get good. One day you'll take a stinger and it's all going to click in your head. Will begin to feel almost natural, then you'll know it all comes together.
No comments:
Post a Comment